Hey Guys
I am ready to install the following release updates for TMG 2010 SP2: TMG Rollup 4 and TMG Rollup5. However I checked the installation directions (from here:http://technet.microsoft.com/en-us/library/ff717843.aspx) first and noticed this caveat:
Before you install the updates on Forefront TMG Enterprise Edition, you must log on to the EMS by using the same credentials that were used to install the EMS during the initial Forefront TMG setup. If you install the update by using a different administrator account, the installation may fail. In this case, you will receive a "Setup cannot initialize Forefront TMG settings" error message.
We do have an Array/Array Manager setup where we have 2 nodes, but we do not use NLB (that I am aware of) and we don't use an EMS Type Array.
If I got to FF TMG >> System >> Servers, under "Config. Management" I see
Server 1 - Array Managed
Server 2 - Array Manager
I think that's the Standalone array configuration and not the EMS array configuration. However the documentation above does state:
These instructions are relevant if you have a standalone array or Enterprise Management Server (EMS). When upgrading Forefront TMG to SP1 or SP2, you must upgrade each of the following, if they exist in your deployment:
- Enterprise Management Servers (master and replicas).
- Array managers.
- Array members.
Basically my question is do I really need to log onto the FF TMG servers as the account that originally installed TMG?
Thanks,
Robert
Robert
