Hi Folks;
I could use a hand with a strange issue I've encountered.
Recently we built a new TMG 2010 VM from scratch (Edge w/2 WAN NICS & 1 LAN). This all works well.
The problem I'm having is with adding another network. In the past, we used TMG 2010 with a separate NIC that went to an open wireless access point. So we created a new network for that and restricted it's access to the WAN only (Internet). This served to separate all traffic from that access point from the internal network. So we had this working well before and it was secure (at least, with respect to the internal network).
Now, this is not working with the new TMG install :(
We created the virtual NIC on the TMG virtual machine, we then created a new network in TMG, as well as a NAT rule to the External network (the WAN). Problem is, it doesn't work.
But the real issue that's preventing me from troubleshooting and repairing this issue is that the TMG 2010 real-time logs show NO results for this new network. If I go on that network and start creating traffic I see NOTHING in the logs on TMG. I've even opened up the logs to show everything and still see nothing from that network.
Nothing has changed on the configuration of the access point and the TMG 2010 NIC that's it's pointing to has the same addressing as with the previous TMG 2010 install. It should work, at least to the extent that I see results in the TMG logs.
What have I forgotten? If I can get to the point where I see traffic in the logs I can create rules as required etc but without log information.....